n. 1.【造船】斜艏桅仰角。 2.起重杆；吊杆。 vt. 1.用起重桅装货。 2.使(斜艏桅)倾斜。 vi. (艏斜桅)倾斜。
例句与用法
1.
As a brand new supporting structure , the steeve - arch was firstly used in the design of tangyu aqueduct ( also used as a bridge ) lies on the eastern main ditch of shitou river , shaanxi province 吊杆式拱架作为一种新型拱式支承结构在陕西省石头河东干渠汤峪渡槽(桥渡结合工程)设计中首创应用。
2.
The name stephenson or stevenson is said to signify , in the norse tongue , the son of steeve , or the strong ; and certainly the subject of this story exhibited , in a remarkable manner , the characteristic quality of his family 斯蒂芬森或斯蒂文森姓氏据说在挪威语中意味着“英勇之子” ，当然，本传记的主题就是以一种独特的方式展示这一家族独具特色的意志品德。
3.
3 , the comparing analyses of tech - economic features , anti - seismic features on transverse direction of the aqueduct 1 ) from the angle of engineering cost , steeve - arch supporting structure , whose down beam have tectonic cracks , can spend less money up to 90 % or more than the usual arch supporting structure , namely steeve - arch supporting structure is very obvious on the side of cost 3 、技术经济比较分析1 )从造价方面看，下弦杆分缝的吊杆式拱架结构相对于下弦杆构造不分缝的竖杆式拱架结构可节约工程造价达到90以上，吊杆拱的经济效果十分明显。
4.
2 ) from the angle of constructing course , steeve - arch supporting structure requires low - capacity cranes to erect , and simple constructing methods easy to meet . the time spending on construction is short . the usual arch supporting structure requires high - capacity cranes to erect , and complicate constructing methods hard to meet 2 )从施工角度看，吊杆式拱架支承结构对吊车的起吊能力要求低，工艺简单，施工方便，工期短；竖杆式拱架支承结构起顶重量大，对吊车的起吊能力要求高，施工难度大。
5.
2 ) the structure elements should be laid out symmetrically and uniformly when designing steeve - arch structure , what ' s more , the reasonable selection of section geometric size near the arch foots of first beams is paid attention to and the arrangement difficulties of steel bar due to the big eccentric pressures 2 , the analyses of anti - seismic features on transverse direction of the aqueduct l ) the method of adjusting the elements " mass can be harnessed in order to even the layout of seismic loads 2 )设计吊杆式拱架支承结构时，各部分构件应当均匀对称布置。另外，还应注意头道梁拱脚附近截面的尺寸拟定，克服地震内力造成的大偏心受压状态给结构配筋设计增加的困难。 2 、横槽向抗震性能分析1 )可利用调整构件质量的方法，使得结构的某些构件的地震荷载分布均匀一些。
您当前位置：